Advertisement
Step 5
Providing the Flash Upgrade is being performed successfully, you should see a
Text
Window with a Progress Bar similar to that shown below.
Step 6
Once the Firmware Upgrade has been successfully completed an extra Window will
appear with a message to this effect. Simply close this Window.
Next, unplug both the Flash Update Cable from both KVM and the Computer, followed
by the power cable to the KVM.
The Dip Switches should then be returned to their original setting – all Dip Switches
set (up) to the 'Off' position.
The KVM can now be powered back on by connecting the Power cable back to the
Power Jack.
The Unit should beep once to indicate power has been added. Once successfully
powered any Computers can be re-connected to the KVM.
N.B.
Should the unit emit a persistent beep after the Flash Update process then it is
indicating that the Firmware has been in some way corrupted. The unit should be re-
flashed using an original Firmware on the same Dip-Switch setting as was last used.
TSG-UK-2-001
TSG-UK-1-001
Self Help Guide
Self Help Guide
®
®
|
|
www.belkin.com
www.belkin.com
|
|
Page 4 of 4
Page 1 of 1
Advertisement
