Nautilus Sport Series Assembly Manual page 23

Figure 12: step 12 Front Motor Cover sticker
Front Motor Cover sticker Location
failure to visually check and test
assembly before use can cause
damage to the Nautilus® Sport
Series treadmill and serious injury to
users and bystanders and can also
compromise the effectiveness of your
exercise program.
bASe ASSembly guide
step 12: installing Front Motor Cover sticker
Locate the following for this step:
Parts:
• assembly from step 11
• Front Motor Cover sticker
12-1 Wipe area beneath aC inlet on Front Motor Cover
with clean dry cloth.
12-2 Carefully adhere the Front Motor Cover sticker
(see illustrations below) to the area and rub to
remove any air bubbles.
T514 & T516: Front Motor Cover sticker
T518: Front Motor Cover sticker
step 13: inspecting Base Assembly
Congratulations!
Now that you have assembled your Nautilus® sport
series treadmill base, Model t514, t516 or t518, it
is VErY IMPOrtaNt to tighten all screws and bolts,
and visually inspect the treadmill. If your treadmill sits
unevenly you may adjust the rear feet with a wrench
to make the treadmill stable on your floor. Make sure
that your treadmill has been assembled correctly and
securely, and that there are no loose, uncovered or
unattached parts prior to assembling the display.
Nautilus® Sport Series Treadmill Assembly Manual