Miele Premier 520 Operating Instructions Manual page 25

I Adding detergent
It is important to dispense the correct
amount, because. . .
. . . too little detergent results in:
– Laundry not getting properly clean
and with time it may become grey
and hard to the touch.
– Greasy particles clinging to the
laundry.
– Limescale deposits on the heater
elements.
. . . too much detergent results in:
– Excessive foam, which causes a low
level of agitation and poor wash,
rinse and spin results.
– higher water consumption because
an extra rinse is automatically
activated
– A burden to the environment.
How to wash correctly
^ Pull out the detergent drawer and
place detergent in the compartments
as follows:
i
Detergent for the pre-wash (divide
the total recommended amount as
1
follows: add /
2 to compartment j). This
and /
3
compartment is also used for starch
formulations when starching
separately.
j
Main wash including the Soak period
if selected
§
Fabric conditioner or liquid starch.
^ Close the detergent drawer.
See section on "Detergent" for further
information on detergent and the
amount to dispense.
J Press the Start button
This starts the programme. The
maximum programme duration will then
show in the display.
to compartment i
3
25