Sound Settings; Volume Control; Selecting Surround Mode - Magnavox MRD723B/F7 Owner's Manual

17. SOUND SETTINGS

17.1 Volume Control

You can control the volume level of the audio output from 5.1ch speakers.
To increase or decrease the volume level: Press [VOL. +/ ].
• The volume level will increase or decrease, every time you press [VOL. +] or [VOL. ].
• The volume level will be displayed on the display panel and the TV screen.
To turn off the volume temporarily: Press [MUTE].
• To restore the volume, press [MUTE] again or press [VOL. +/ ].
• "MUTE" will be displayed on the display panel and
D Note
• This function is only available for the audio output from 5.1ch speakers.
• Pressing [VOL. +/ ] does not work while the setup menu is displayed.
• If you turn up the volume too much, the audio may get distorted. To enjoy clear sounds, please turn down the
volume.

17.2 Selecting Surround Mode

Select the surround mode for the audio output from 5.1ch speakers.
1. During playback, press [SURROUND], then use [Î / ï] to select the desired surround mode.
"Direct":
Selects the appropriate audio decoder (stereo / multi-channel Dolby, DTS
stream.
"2.1ch Stereo":
Set the surround mode to "2.1ch Stereo". (2.1ch Stereo sound from front left/right speakers.)
"Multi ch Stereo":
Set the surround mode to "Multi ch Stereo". (5.1ch stereo sound from 5.1ch speakers.)
"Dolby Pro Logic II Movie":
Set the surround mode to "Dolby Pro Logic II Movie". (Dolby Pro Logic II 5.1ch surround sound.)
"Dolby Pro Logic II Music":
Set the surround mode to "Dolby Pro Logic II Music". (Dolby Pro Logic II 5.1ch surround sound.)
D Note
• During playback of network download service, press [SURROUND] repeatedly to select the desired surround
mode. (The setting does not appear on the TV screen.)
• The availability of surround sound modes will depend on the audio source.
• In disc or SD Memory Card mode, pressing [SURROUND] does not work while in the Resume-On-Stop mode.
• In FM mode, pressing [SURROUND] does not work when no audio is being input.
• Pressing [SURROUND] does not work during playback of JPEG files.
• This function is effective only for the audio output from 5.1ch speakers.
will be displayed on the TV screen.
®
or PCM) based on the input audio
Continued on next page.
EN-67