Electrolux ES510 Use And Care Manual page 11

Fig. 1
Fig. 2
Fig. 5
Setting Surface Controls
To Operate the Bridge Element (some models):
1. Place correctly sized cookware on the Bridge surface
2. Push in and turn the control knob counterclockwise (See
3. Use the ESEC digital display window for the desired
4. When cooking has completed, turn the surface control
Fig. 3
The BRIDGE element may also be used in combination with the
left rear single element. Because these elements have 2
Fig. 4
different controls, one element can be used to cook while the
other element may be used to keep food warm (See Fig. 5).
cooled after they have been turned off. The glass surface may
still be hot and burns may occur if the glass surface is
touched before it has cooled sufficiently.
11
element.
Figs. 1 & 2) to heat the portion of the Bridge element for
normal shaped cookware or clockwise (See Figs. 3 & 4) for
larger or rectangular shaped cookware.
setting. Turn (do not push) the knob to adjust the setting if
needed. Start most cooking operations on a higher setting
and then turn to a lower setting to finish cooking. Each
surface element provides a constant amount of heat at
each setting. A glowing red surface heating area extending
beyond the bottom edge of the cookware indicates the
cookware is too small. Please note that not all cookware
will fit the Bridge element correctly.
knob to OFF before removing the cookware. The HE
message will appear in the display after turning the control
knob to OFF if the cooktop is still hot and will remain on
until the radiant heating surface area has cooled
sufficiently. Note: See page 8, Fig. 5 for recommended
control settings.
Radiant surface elements may appear to have