Electrolux EW30IS65JS Specifications page 2

Induction Built-In Range
EW30IS65J S
Side
Overall
depth
including
oven door
in 90 open
position –
45 1 / "
4
Front
30" Induction Built-In Range Specifications
Product Weight – 250 Lbs.
•
Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz,
•
fused on both sides of line with ground. (If local code permits, range may
be connected by hard-wiring or by means of power supply cord kit.)
Connected Load (kW Rating) @ 240 / 208 Volts = 13.2 / 9.9 kW
•
Amps @ 240 / 208 Volts = 55 / 48 Amps
•
Recommended Circuit Breaker – 50 Amps
•
Always consult local and national electric codes.
•
Countertop MUST be level in all directions and adjustable range
•
height at least 1/16" greater than tallest cabinet height, to ensure metal
rangetop flange will fit properly on countertop edge.
When installing optional Backguard Kit, cutout depth of 21-3/4"
•
minimum / 22-1/8" maximum needs increased to 24".
Overhead cabinetry should not exceed a 13" maximum depth.
•
Absolute minimum horizontal distance between overhead cabinets
•
installed to either side of appliance must be no less than maximum width
of appliance.
Allow 24" minimum clearance between rangetop and bottom of cabinet
•
when bottom of wood or metal cabinet is protected by not less than 1/4"
flame-retardant millboard covered with not less than No. 28 MGS sheet
steel, 0.015" stainless steel, 0.024" aluminum or 0.020" copper. Allow
30" minimum clearance when cabinet is unprotected.
To reduce risk of fire when using overhead cabinetry, install range hood
•
that projects horizontally a recommended minimum of 5" beyond bottom
of cabinets.
When installing range into existing cutout depth greater than 22-1/8",
•
optional 2" Rear Filler Kit available.
Electrolux Major Appliances, N.A.
250 Bobby Jones Expressway
USA
•
CANADA 5855 Terry Fox Way Mississauga, ON L5V 3E4
• •
EW30IS65J 01/10
28 5 / "
16
Shave raised
27 1 / "
2
edge to clear
space for
31 1 / " wide
2
cooktop rim
WALL
Power
supply
location
(left
bottom
rear)
25 3 / "
4
13 / "
31 1 / "
16
2
35 5 / "
8
Adjustable
to
36 5 / "
8
30"
Augusta, GA 30907 1-877 -4electrolux (1-877 -435-3287)
• •
1-800-265-8352
•
© 2010 Electrolux Home Products, Inc.
1 1 / "
2
max.
3 / " min.
8
1 / " min.
2
21 3 / " min.
4
Hatched area 22 1 / " max.
8
should be flat
and leveled
Approx.
1 7 /
Locate cabinet
doors 1" min.
from cutout
opening
30
*Cabinet and countertop **24" with optional
cutout width should match backguard installed
Countertop
Locate grounded junction box
or wall outlet 8" - 17" from right
22 7 / " min.
8 cabinet and 2"- 4" from floor
23 1 / " max.
4
1 1 / "
8
21 3 / " min.
4
**
22 1 / " max.
8
Front Face of Cabinet
Countertop Preparation
For detailed preparation instructions, refer to installation guide on the web.
Flat square-finish (flat) countertop requires no preparation since rangetop
•
flange lays directly on countertop edge.
Formed front-edged countertops require front molded edge to be shaved
•
flat 3/4" from each front corner of opening.
Tile countertops may need cut back 3/4" from each front corner of
•
opening and / or rounded edge flattened.
For existing cutout width greater than 30-1/16" reduce the 3/4" overlap
•
dimension or for cutout width of 29", replace actual side trim panels with
smaller side trim panels, available with optional Side Trim Kit (refer to
detailed kit installation instructions).
Note: For planning purposes only. Refer to Product Installation Guide
on the web at electroluxappliances.com for detailed instructions.
Optional Accessories
2" Rear Filler Kit: S – (PN # 903113-901S).
•
Side Panel Kit: S – (PN # 903102-901S).
•
Backguard Kit: S – (PN # 903111-901S).
•
Side Trim Kit: S – (PN # 903110-901S).
•
electroluxappliances.com
•
electroluxappliances.ca
•
30" min.
max.
24" min. clearance
with protected cabinet bottom
30" min. for unprotected
min.
1 / " min.
2
30 1 / "*
16
**
35 3 / "
4
min.
36 5 / "
8
" max.
8
24"min.
31 1 / "
2
(critical)
1
/ "*
16
High standards of quality at Electrolux Home Products, Inc. mean
we are constantly working to improve our products. We reserve the right
to change specifications or discontinue models without notice.
13"
18"
Printed in the U.S.A.