Set Up Cubase ® Le For Io 22 (Windows ® ) - Lexicon I-O|22 Owner's Manual

14
Set Up Cubase LE for IO 22 (Windows
®
1. Make sure the included USB cable is connected to your computer and to
the IO 22 and the IO 22 is turned on.
2. Start Cubase ® LE (from the Start menu under Lexicon
3. If you see the warning shown below, click OK.
4. Once you are in Cubase LE, go to Devices>Device Setup.
5. Under Devices, click on VST Audio System and select Lexicon IO 22
from the ASIO Driver pull-down menu if it is not already selected. Click
on Switch to switch the driver, then click OK in the Device Setup dialog.
You are now ready to begin recording using your IO 22 and Cubase LE.
Note: In many cases you can improve performance by selecting a higher
latency setting from the System Performance drop-down menu on the ASIO
control panel (Devices > Device Setup > Lexicon IO 22 > Control Panel
> ASIO).
)
®
® ).