Self-Cleaning Cycle Does Not Work; Solutions To Common Problems; Soil Not Completely Removed After Self-Cleaning Cycle Is Completed; Flames Inside Oven Or Smoke From Vent - Electrolux E30DF74GPS Use And Care Manual

36

Solutions to Common Problems

SELF-CLEANING CYCLE DOES NOT WORK

• Make sure the oven door is closed.
• Make sure the two oven rack ladders are removed from the oven.
• Controls not set properly. Follow instructions.
• Self-cleaning cycle was interrupted. Start a clean again, wait 20 seconds for the Lock
light to stop flashing, turn off the clean and wait again 20 seconds for the light to turn off.
SOIL NOT COMPLETELY REMOVED AFTER SELF-
CLEANING CYCLE IS COMPLETED
• Failure to hand clean oven frame and door liner outside the oven door gasket before
starting the self-clean cycle. Hand clean burned on residue with a stiff nylon brush and
water or a nylon scrubber. Do not clean the oven door gasket or it will be damaged.

FLAMES INSIDE OVEN OR SMOKE FROM VENT

• Excessive spillovers in oven. This is normal, especially for high oven temperatures, pie
spillovers or for large amounts of grease on bottom of oven. Wipe up excessive
spillovers.