Installing The Operator Assembly Onto The Mounting Plate - SkyLink DM-100 User Instructions

INSTALLATION - OUT SWING
6. Attach the door arm assembly on the operator
6.1 The door should remain at the fully closed position.
6.2 Slide one end of the arm assembly (the end with the slider)
into the slider bracket.
6.3 Place the other end of the arm assembly on top of the
operator motor shaft. You may notice the arm assembly
coupling is not fully seated into the slots of the operator
motor shaft. In order for the arm assembly to seat fully into
the slots of the operator motor shaft, open the door slowly to
about 75 degrees from the fully open position. You should
feel the arm is now seated all the way into the slots, and
you can visual check to confirm.
6.4 Tighten the arm assembly to the operator motor shaft by a screw, spring washer, and a flat washer.
Actual size
x1
x1
x1
Slider
Arm is seated
fully into the
shaft.
~75°
– –
21
INSTALLATION - OUT SWING
7-1/2" (Approx. 190mm)
Slider bracket
Note: Out-Swing right door installation shown.
3.

Installing the operator assembly onto the mounting plate

3.1 Remove the 2 side covers from the operator by sliding them out.
3.2 Place the operator onto the mounting plate based on the door type. For
instance, for out swing right door, the "OUT-SWING RIGHT" holes should
match the 2 top holes of the operator.
3.3 Secure the operator to the mounting plate with 6 nuts, spring washers and
bolts.
IN-SWING RIGHT
Top 2 screws match the
2 holes with marking
OUT-SWING RIGHT
"OUT SWING
RIGHT".
FT LE G IN T-SW OU
LEFT G N -SWI IN
For Out-Swing Left installation, place the top
2 screws of the door opener to these 2 holes.
Actual size
7-1/2" (Approx. 190mm)
Slider bracket
Note: Out-Swing left door installation shown.
Remove
side cover
WARNING
To avoid possible serious
injury from a falling door
operator, fasten it securely
to the mounting plate and
the supports of the door.
x6 x6 x6
– –
18
Remove
side cover