Advertisement
Hitch & Tube Group
DISCHARGE TUBE ASSEMBLY
1. Connect the flexible hose (F, Figure 6) and clear
plastic discharge tube (B). The two should overlap
by approximately 2".
2. Secure the tubes using truss head screws (E), wash-
ers (D), and locknuts (C). Insert the screws from the
inside out and poke them through the flexible hose.
3. Insert the upper end of the clear tube into the cart
sleeve. Slide the flex hose (F) over the turbo (H) and
secure with the large hose clamp (G). The hose
should overlap the turbo discharge by 2"-3".
The clamp screw should be positioned to the inside
as shown to prevent accidental impact and removal
of the clamp.
Check that the upper end of the clear tube (B, Figure
6) is not contacting the top of the collector cover. If
necessary, cut off the clear tube flush with the sleeve
(See Wide Body Cart Operators Manual).
D
E
F
G
G
H
Figure 6. Discharge Tube Installation
A. Decal
B. Discharge Tube
C. Locknut, Hose
D. Washer
3
Installation Instructions
A
B
C
F
E. Truss Head Screw
F. Hose
G. Clamp
H. Turbo Discharge
Advertisement
