Using The V.reader Tm Touch Screen; Cleaning The V.reader Tm Touch Screen; Inserting An Sd Card - VTech V.Reader Interactive E-Reading System User Manual

Using the V.Reader
V.reader
has a touch-sensitive screen that you can interact with by using your
tM
finger or the included pen. Lightly touch the screen with your finger or the pen.
note:
• Use only enough pressure to operate the game. Too much pressure may
damage the touch screen.
• Do not use the pen if it is broken.
• Do not use any other pens on the touch screen other than the V.reader
• Put the pen back in the pen holder when not in use.
Cleaning the V.Reader
If the screen on your V.reader
on it, you can clean it with the included soft cloth.
1. Slightly dampen the cloth with an alcohol-based cleaner and wipe the screen
to loosen dirt.
2. Using a clean, dry cloth, wipe the screen dry. Repeat these two steps as
needed.

Inserting an SD Card

Inserting an SD Card
You can insert an SD card (not included) into your V.reader
content.
• Make sure the unit is turned off.
• Open the battery cover, as shown in image 4.
• Make sure the batteries have been removed.
• Locate the SD card slot inside the battery cover.
• Insert the SD card as shown in image 5.
• Make sure to replace the battery cover.
Touch Screen
TM
or
MENU GAME HIGHLIGHT MUSIC OFF
MENU GAME HIGHLIGHT MUSIC OFF
Touch Screen
TM
has visible smudges, fingerprints or other material
tM
pen.
tM
, to store downloaded
tM