Adjustments - Ryobi TS1343L Operator's Manual

DANGER:
Laser radiation. Avoid direct eye contact with light source.
WARNING:
Use of controls or adjustments or performance of pro-
cedures other than those specified herein may result in
hazardous radiation exposure.
TO ADJUST THE LASER GUIDE
See Figure 37.
 Use the work clamp or a C-clamp to secure a piece of
scrap wood.
 Plug the saw into the power source and make a slight
cut to score the wood.
 Release the switch trigger and allow the saw blade to
stop rotating before raising the blade.
 Raise the saw arm.
 Unplug the saw.
 To adjust the laser, loosen the laser adjustment screw
using the Phillips end of the supplied blade wrench.
NOTE: When properly aligned, the laser should be on the
left edge of the kerf.
 Once aligned, tighten the screw then remove the blade
wrench.

ADJUSTMENTS

LASER
ADJUSTMENT
SCREW
28
Fig. 37