Gigabyte GA-M55SLI-S4 User Manual page 75

Step 5:
Next, select the hard drives which you wish to be included in the disk array. The Free Disks section
displays the information about the currently installed SATA hard drives. Press the TAB key to move to
the Free Disks section. Select the target hard drives using the UP or DOWN ARROW key and use the
RIGHT ARROW key to add the hard drives to the Array Disks section (Figure 5).
RAID Mode: Striping
Free Disks
Loc Disk Model
[ESC] Quit [F6] Back
Step 6:
Press F7 after selecting the target hard disks. A message which says "Clear disk data?" will appear
(Figure 6). If you are sure to clear the data in the selected hard drives, press Y. (If the hard drives
contain previously created RAID array, you need to press Y to clear the data from the hard drives.)
RAID Mode: Striping
Free Disks
Loc Disk Model
[ESC] Quit [F6] Back
MediaShield Utility Mar 22 2006
- Define a New Array -
Striping Block:
Array Disks
Capacity Loc
[ ] Add
[ ] Del
[F7] Finish [TAB] Navigate
Figure 5
MediaShield Utility Mar 22 2006
- Define a New Array -
Striping Block:
Array Disks
Clear disk data ?
Capacity
Clear disk data ?
[Y] YES [N] NO
[ ] Add
[Y] YES [N] NO
[ ] Del
[F7] Finish [TAB] Navigate
Figure 6
- 75 -
Optimal
Disk Model
2.0.M ST3120026AS
2.1.M ST3120026AS
[ ] Select [ENTER] Popup
Optimal
Loc Disk Model
1.0.M ST3120026AS 111.79GB
1.1.M ST3120026AS 111.79GB
[ ] Select [ENTER] Popup
Capacity
111.79GB
111.79GB
Capacity
Appendix