Integrated Peripherals - Gigabyte GA-Z68X-UD3H-B3 User Manual

2-6

Integrated Peripherals

CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
eXtreme Hard Drive (XHD)
PCH SATA Control Mode
OROM UI and Banner
SATA Port0-3 Native Mode
USB Controllers
USB Legacy Function
USB Storage Function
Azalia Codec
Onboard H/W 1394
Onboard H/W LAN
 SMART LAN
Onboard LAN Boot ROM
R_USB30 Controller
R_USB30 Turbo
F_USB30 Controller
GSATA3 Controller
GSATA3 Ctrl Mode
Onboard Serial Port 1
higf: Move Enter: Select
F5: Previous Values
eXtreme Hard Drive (XHD) (Intel Z68 Chipset)
Enables or disables the X.H.D function for the SATA controllers integrated in the Intel Z68 Chipset. When
set to Enabled, the PCH SATA Control Mode item below will be set to RAID(XHD) automatically. For
details on using the GIGABYTE X.H.D utility, refer to Chaper 4, "eXtreme Hard Drive (X.H.D)." (Default:
Disabled)
PCH SATA Control Mode (Intel Z68 Chipset)
Enables or disables RAID for the SATA controllers integrated in the Intel Z68 Chipset or configures the
SATA controllers to AHCI mode.
IDE Disables RAID for the SATA controllers and configures the SATA controllers to IDE
mode. (Default)
RAID(XHD) Enables RAID for the SATA controllers.
AHCI C onfigures the SATA controllers to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specification that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
OROM UI and Banner
Determines whether to display Intel RAID ROM messages during the POST when the Intel SATA RAID
function is enabled. (Default: Enabled)
SATA Port0-3 Native Mode (Intel Z68 Chipset)
Specifies the operating mode of the integrated SATA controllers.
Disabled Allows the SATA controllers to operate in Legacy IDE mode.
In Legacy mode the SATA controllers use dedicated IRQs that cannot be shared with
other device. Set this option to Disabled if you wish to install operating systems that
do not support Native mode.
Enabled Allows the SATA controllers to operate in Native IDE mode.
Enable Native IDE mode if you wish to install operating systems that support Native
mode. (Default)
BIOS Setup
Integrated Peripherals
[Disabled]
[IDE]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Auto]
[Enabled]
[Enabled]
[Press Enter]
[Disabled]
[Enabled]
[Disabled]
[Enabled]
[Enabled]
[IDE]
[3F8/IQR4]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
- 50 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults