Preparation - Fujitsu ASTG09LVCA Operating Manual

PREPARATION

Turn on the Power
1
Turn on the circuit breaker.
Load Batteries (R03/LR03 × × × × × 2)
1 Press and slide the battery compartment lid on the re-
verse side to open it.
Slide in the direction of the arrow while pressing the
2 Insert batteries.
Be sure to align the battery polarities (
3 Close the battery compartment lid.
Set the Current time
1 Press the CLOCK ADJUST button (Fig. 5 S).
Use the tip of a ball-point pen or other small object to press the button.
2
Use the TIMER SET (
adjust the clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed
in one-minute increments; hold the buttons depressed to change the time
quickly in ten-minute increments.)
Press the CLOCK ADJUST button (Fig. 5 S) again.
3
This completes the time setting and starts the clock.
To Use the Remote Controller
G The Remote Controller must be pointed at signal receiver (Fig. 1 4) to operate
correctly.
G Operating Range: About 7 meters.
G When a signal is properly received by the indoor unit, a beeping sound will be
heard.
G If no beep is heard, press the Remote Controller button again.
Remote Controller Holder
Press in
Screws
1 Mount the Holder. 2 Set the Remote Controller.
En-5
) buttons (Fig. 5 R) to
/
Insert
mark.
) correctly.
Slide up
Pull out
3 To remove the Remote
Controller (when use at
hand).
CAUTION!
G Take care to prevent infants from
accidentally swallowing batteries.
G When not using the Remote Controller
for an extended period, remove the
batteries to avoid possible leakage and
damage to the unit.
G If leaking battery fluid comes in contact
with your skin, eyes, or mouth, immedi-
ately wash with copious amounts of
water, and consult your physician.
G Dead batteries should be removed
immediately and disposed of properly,
either in a battery collection receptacle
or to the appropriate authority.
G Do not attempt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about one year
under normal use. If the Remote
Controller's operating range becomes
appreciably reduced, replace the batter-
ies and press the RESET button with the
tip of a ballpoint pen or other small
object.