Table of Contents
Advertisement
5.
Drill the radiator air inlet duct using a 1
1/8" hole saw so that the hose can be
routed smoothly from the water cooler
to the water pump outlet.
6.
Install the water cooler assembly
between the power steering cooler and
the hood latch mechanism.
Bolt the power steering cooler to the
7.
brackets at the lowest location using the
supplied hardware.
Bolt the brackets to the hood latch
8.
mechanism using the factory hardware.
(See Fig. 8-h.)
Fig. 8-h
9.
Connect the outlet of the water pump to
the far side of the water cooler with the
installed 3/4" hose trimmed to fit.
P/N: 4809644
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
13DEC04 v2.0 03-05Viper(4809644v2.0)
10. Route 90º 3/4" hose between the radia-
tor and the passenger side frame rail.
Install a 90º hose on the top fitting on
the CAC core with the short leg
trimmed as short as possible. Connect
the two hoses using a supplied hose
mender. (See Fig. 8-i.)
11. Verify that clamps have been installed
and tightened on each hose connection
and that all hoses are routed as smooth-
ly as possible.
12. Remove the cap and fill the system
with 25%/75% coolant/water mix. Fill
system slowly and completely.
FLOW
Fig. 8-j
8-4
Fig. 8-i
Advertisement
Table of Contents
