Paxton Automotive Viper Owner's Installation Manual page 20

Install the 3/8 x 2-3/4" bolt through the
F.
mounting plate assembly and into the open
hole in the supercharger gear case. Install
the 3/8 x 2-1/4" bolt in the open hole at the
bottom of the supercharger plate and thread
into the primary plate. (See Fig. 6-c.)
2-3/4" BOLT
Fig. 6-c
G. Install the 5/16" nut and washer on the A/C
stud and a 3/8" nut and washer on the lower
alternator stud.
*** NOTE ***
The front of the lower alternator stud is difficult to
reach. Try to start and thread on front nut by hand.
Final wrench tightening can be done on the rear nut
which is accessable.
H. Install the supercharger belt onto the super-
charger pulley. Make sure that the 8-rib
grooved idler is seated square on the spacer
pilot and install a nut and washer on its
retaining bolt.
*** NOTE ***
In order to provide belt clearance to the shock tower
brace, the supercharger pulley may interfere with the
alternator pulley. Carefully check the following:
I. Check the supercharger pulley nose to alter-
nator belt clearance. If necessary, lift the
supercharger assembly while tightening the
mounting plate fasteners. Tighten all of the
mounting plate assembly fasteners. Verify
that the nose of the supercharger pulley
is not touching the accessory drive belt.
Loosen and then remove the previously
J.
installed spring tensioner retract tool from
the supercharger mounting plate.
P/N: 4809644
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
13DEC04 v2.0 03-05Viper(4809644v2.0)
2-1/4" BOLT
6-2
K. Route the free end of the oil feed hose to the
supercharger oil feed fitting
*** NOTE ***
Make sure there are no bends, kinks or dips in the oil
drain line. The hose must maintain a constant "down-
hill" routing. Restriction in the drain path may cause
seal leakage and/or supercharger failure
L. Attach the free end of the oil drain hose to
the previously installed oil drain fitting in
the oil pan and secure with a #8 hose clamp
(cut hose for best fit).
M. Use zip-ties as necessary to secure the oil
drain and oil feed lines away from moving
parts.