Table of Contents
Advertisement
L. Connect the TAN/YELLOW wire to the
wire leading to the PCM cam sensor input.
(See Fig. 7-c.)
M. Connect the large 12 GAGE RED wire to
the battery (+) positive terminal located at
the front of the fuse box.
N. Reinstall the PCM C1 connector.
O. The two STRIPED RED wires will be used
to power the fuel pumps in the following
section.
TO POWER
TERMINAL AT
FRONT OF
FUSE BOX
TO
ENGINE/
SENSORS
P/N: 4809644
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
13DEC04 v2.0 03-05Viper(4809644v2.0)
WILL BE CONNECTED
IN SECTION 9
(SEE FIG. 9-C.)
Fig. 7-c
RED
RED/BLACK
RED/GREEN
RED - 20
BLACK - 20
SUPPLIED
IGNITION
VIOLET - 20
CONTROL BOX
GRAY
GRAY/BLACK
TAN
TAN/YELLOW
PINK/GRAY
DARK BLUE/DARK GREEN
GRAY/BLACK
TAN/YELLOW
7-2
TO FACTORY
POWERTRAIN
CONTROL
MODULE
(PCM)
Advertisement
Table of Contents
