2X3 Crossover - dbx DriveRack PA User Manual

DriveRack
Hardware
1.
2. Connect the outputs of the DriveRack
3. Make sure that the mixer and power amps are turned off prior to powering up the
Software
1. Use the Wizard to setup the specific program.
2. Once the program has been chosen, press the DATA wheel to load the program.
®
®
®
®
PA
Connect the outputs from the mixer to the inputs of the DriveRack
®
DriveRack PA.
Left
Mono Low
®
Application Guide
® PA and run to the selected speaker amplifier.
Right
Left High
EON15 G2
®
®
DriveRack
Section 5

5.4 - 2X3 Crossover

®
.
Right High
EON15 G2
MP4718S
Non-Powered
® PA User Manual 33