Detachable Power Cord Socket; Digital Out; H-P/St (Glass Fibre) Optical Input; Aes/Ebu Xlr Input - Sonic Frontiers SFD-2 MK-II Owner's Manual

G
G -Detachable Power Cord Socket - Plug the Detachable
Power Cord into this socket (see Figure 1). The SFD-2 MKII is
factory set for the correct operating voltage for the area in
which it is sold (see shipping box for voltage setting). If a differ-
ent operating voltage is required, please contact an authorized
Sonic Frontiers dealer, distributor or the factory directly.
H -Digital Out - This output jack provides a digital signal for
dubbing purposes with a Digital Audio Tape (DAT) or
Compact Disc recorder (CD-R).
I - H-P/ST (Glass Fibre) Optical Input - This input will
accept a digital connection from a digital source's Glass Fibre
Optical digital output. This connection type is considered best for
optimum performance and sound quality; if your source unit has
this type of digital output, we recommend its use.
J - Toslink (Plastic Fibre) Optical Input - This input will
accept a digital connection from a digital source's Toslink
(Plastic Fibre) Optical digital output.
K - Coaxial BNC Cable Input - This input will accept a digital
connection from a digital source's BNC - Coaxial digital out-
put. The BNC - Coaxial cable impedance should be 75 ohms.
L - Coaxial RCA Cable Input - This input will accept a digital
connection from a digital source's RCA - S/PDIF - Coaxial digi-
tal output. The RCA - S/PDIF - Coaxial cable impedance
should be 75 ohms.
L
H I J K
M-AES/EBU XLR Input - This input will accept a digital signal
from a digital source's AES/EBU XLR digital output. A 110
ohm balanced cable terminated with XLR plugs should be used
for this connection.
NOTE: The XLR jack pin connectors for the SFD-2 MKII are
configured as follows:
N- Left and Right Channel Balanced XLR Audio
Output Connectors - These are balanced audio outputs
and should be used when connecting the SFD-2 MKII to the
balanced audio inputs of a line level preamplifier, control
amplifier, integrated amplifier or receiver, if these units are so
equipped (see Figure 4). (Left channel output of the SFD-2 MKII
connects to the left channel input of control unit and right
channel output of the SFD-2 MKII to the right channel input of
control unit.)
NOTE: The XLR jack pin connectors for the SFD-2 MKII are
configured as follows:
O-Left and Right Channel RCA Single-Ended Audio
Output Connectors - If the balanced inputs are not applica-
ble for use, the RCA single-ended (unbalanced) audio outputs
should be used when connecting the SFD-2 MKII to the RCA
single-ended audio inputs of a line level preamplifier, control
amplifier, integrated amplifier or receiver. (Left channel output of
the SFD-2 MKII connects to the left channel input of control unit
and right channel output of the SFD-2 MKII to the right channel
input of control unit.)
M
Pin #1 : Ground
Pin #2 : Positive (+) Phase
Pin #3 : Negative (–) Phase
Pin #1 : Ground
Pin #2 : Positive (+) Phase
Pin #3 : Negative (–) Phase
O
N