American DJ Stage Desk 16 User Instructions page 9

Step 3:
Move the Speed Slider level to its minimum level.
Step 4:
You may now use the audio slider to adjust the music sen-
sitivity. The music sensitivity will automatically control either
the internal microphone or an audio input signal connect to
the rear of the controller.
Running a Chase Pattern with the Tap Sync:
This mode will allow to run your patterns to your deter-
mined speed rate. In this mode you manually enter a
speed rate by tapping on the Tap Sync Button. You can
use this function to create a constant rate to the beat of
the music by tapping the Tap Sync to the beat.
Step 1:
Be sure the Audio, Speed, and Fade Time Sliders are set to
lowest levels.
Step 2:
Select your desire chase patterns
Step 3:
Tap the Tap Sync Button at a regular rate. You will notice
that the chase pattern will begin to advance at the same
rate you were tapping.You will also notice that the Tap Sync
LED will flash at the same rate you were tapping on the Tap
Sync Button.
Step 4:
You can override this setting at any time by selecting the "Audio Function."
You may also clear this setting by raising the Speed Slider to it's maximum
level.
Running a Chase Pattern Using the Glide Function:
This mode will allow to run your patterns to a preset fade time. This gives
the effect of one scene fading in to the next. This function is used in con-
junction with any of the other three operating modes
Step 1:
American DJ Supply www.americandj.com Stage Desk-16™ Instruction Manual Page 17
© ®
Operation Cont.
Step 3
Step 4
Step 2
Tap Sync
Step 3
While in any of the other operating modes, press the Glide
Button. The Glide LED will begin to glow indicating the glide
function has been activated.
Step 2:
With the glide function activated press the Chase Pattern
Button that stores the chase you wish to run in glide mode.
If the chase is already running you must deselect it and re
select it in order for the glide function to be activated.
Step 3:
To discontinue the glide effect, deselect the Glide Button
and deselect the Chase Pattern that is running, or press the
Blackout Button.
Kill Function:
This function allows you to remove specific channels from a chase or
scene. You may take out as many channels from a scene or chase pat-
terns as you would like. Please note, After you remove a channel from
a chase or scene, the channel's fader level LED will continue to remain
lit for a scene, or continue to flash for a chase pattern. This is normal
and serves as a reminder that channel is programmed into your scene or
chase. Be sure that although the channel LED is on the channel is not
producing any output. To add a KILL:
Step 1:
Press the Kill Button to activate the Kill Mode, a yellow LED will begin to
glow indicating Kill Mode has Been activated.
Step 2:
Press the Flash Buttons for the channels you wish to remove from the
chase pattern.
Step 3:
The channels you selected will now discontinue output. To return to
normal operation, tap the Kill Button once again.
Add Function:
This function allow you to turn on more than one chase pattern on the
same bank. Without this function you may turn on more than one chase
pattern as long as they are in different banks. In order to run more than
American DJ Supply www.americandj.com Stage Desk-16™ Instruction Manual Page 18
© ®
Operation Cont.
Step 2
Step 3