ECS G41T-M Manual page 37

Boot Up Numlock Status (On)
This item defines if the keyboard Num Lock key is active when your system is
started.
APIC Mode (Enabled)
This item allows you to enable or disable the APIC (Advanced Programmable Inter-
rupt Controller) mode. APIC provides symmetric multi-processing (SMP) for sys-
tems, allowing support for up to 60 processors.
1st/2nd/3rd Boot Device (Hard Disk Drive/CD/DVD/Removable Dev.)
Use this item to determine the device order the computer used to look for an
operating system to load at start-up time. The devices showed here will be different
depending on the exact devices installed on your motherboard.
Hard Disk Drives (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Hard Disk Drives
1st Drive
2nd Drive
: Move
F1: General Help
Press <Esc> to return to the Advanced Setup page.
CD/DVD Drives (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
CD/DVD Drives
1st Drive
: Move
F1: General Help
Press <Esc> to return to the Advanced Setup page.
Boot Other Device (Yes)
When enabled, the system searches all other possible locations for an operating
system if it fails to find one in the devices specified under the First, Second and Third
boot devices.
Hard Disk Drives
ST31000340AS Specifies the boot
SD/MMC Card
sequence from the
available devices.
Enter : Select +/-/: Value
F10: Save ESC: Exit
F9: Load Default Settings
CD/DVD Drives
Specifies the boot
DVD-ROM DDU1632
sequence from the
available devices.
Enter : Select +/-/: Value
F10: Save ESC: Exit
F9: Load Default Settings
Using BIOS
33
Help Item
Help Item