E-Mu 404 Owner's Manual page 23

Tutorials
6. Select Device Setup... from the Devices menu.
7. Select VST Multitrack from the Devices list.
8. In the Setup section of the dialog box, select ASIO E-MU 0404|USB. A pop up
dialog box asks, if you want to keep or switch the ASIO driver. Select Switch.
Buffer Latency Setting
9. Click the Control Panel button. The pop-
up dialog box shown at right appears.
10. Set the ASIO Buffer Latency as low as
your computer will allow and click OK.
(10ms is a good starting point.)
A low latency setting is important to
assure fast response when using virtual
instruments and to minimize delay when
monitoring through Cubase. If you hear crackles or other audio problems, try
increasing the Buffer Size.
11. Close the Device Setup screen by clicking OK.
12. Note: If the Cubase LE application crashes for any reason, it is recommended
that you re-boot the computer.
13. Select Project Setup from the Project menu. This is where you set the Sample
Rate and Record Format (bit depth), among other things. Set the Record
Format to 24-bits and the Sample Rate to 44.1kHz.
0404 USB 2.0 Owner's Manual 23