Advertisement
Cross Flash™
Please carefully read and understand the instructions in this manual
thoroughly before attempting to operate this unit. These instructions
contain important safety information regarding the use and mainte-
nance of this unit. Please keep this manual with the unit, for future ref-
erence.
Cross Flash™
Safety Issues: This unit may blow a fuse if the maximum allotted
load of 3 amps is reached. If the fuse needs replacement, always
replace the fuse with same exact type that was remove, unless other-
wise instructed by an authorized American DJ
of a different type fuse from that which is recommended may cause fire
or electric shock and will void the manufactures warranty.
•
Keep the outside of this device dry at all times. Do not spill water or
other liquids into or on to your unit. To prevent fi re or shock hazard,
do not expose this product to rain or moisture.
•
Be sure to save the packing carton in the event you may have to
return the unit for service.
•
This unit is designed for interior use only. Do not use this unit out
doors. Use of product outdoors will void the warranty.
•
Be sure that the local power outlet match that of the required volt-
age for your unit.
•
Do not attempt to operate this unit if the power cord has been
frayed or broken.
•
Always route your power cord out of the way of foot traffi c.
•
Do not attempt to remove or break off the ground prong from the
electrical cord. This prong is used to reduce the risk of electrical
shock and fi re in the rare case of an internal short.
•
Disconnect the unit's main power when left unused for long periods
of time.
•
Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6" (15cm) between this device and a wall.
•
Never block the ventilation holes.
•
Do not attempt to operate this unit, if it becomes damaged in any
way.
•
Never operate this unit when it's cover is removed.
•
This unit is for adult use only. Keep out of the reach of children.
American DJ Supply
- www.americandj.com - Cross Flash™ Instruction Manual Page 3
©
®
General Instructions
Precautions
service technician. Use
®
Cross Flash™
• 6 Colors / 6 Beams at Once
• Wide Beam Spread
• Easy Lamp Replacement
• Compact Case Design
• Built-In Hanging Yoke
• Bright 300 Watt Lamp
• Internal Microphone with Sound Sensitivity Knob
• Fan Cooled
Cross Flash™
Power Supply:
Before plugging your unit in, be sure the source
voltage in your area matches the required voltage for your American
DJ
Cross Flash™ before attempting operation.
®
General Operation:
Just plug this light in, and watch it go. This
fixture is designed to operate as a stand alone unit. It has been tested
and the lamp has been installed at the factory there is no assembly
necessary. The Cross Flash™ is ready to be plugged in, out of the
box. There is no power switch, after plugging the unit the unit will
slowly light up and rotate in a single direction. If there is no lamp
output check the fuse and bulb. If the fuse and bulb are good, please
return the unit for servicing.
Sensitivity Knob:
A sound sensitivity knob is located on the rear of
the unit. Use this knob to control amount of sound it takes to trigger
the unit. Turning the knob in a clockwise direction will increase the
units sensitivity to sound, turning the knob in a counterclockwise
direction will decrease the units sensitivity to sound.
Cross Flash™
This fixture is fitted with halogen lamps which are
highly susceptible to damage if improperly handled.
Never touch the lamps with your bare fingers as
the oil from your hands will shorten lamp life. Also,
never move the fixture until the lamps have had
ample time to cool. Remember, lamps are not cov-
ered under warranty conditions.
American DJ Supply
- www.americandj.com - Cross Flash™ Instruction Manual Page 4
©
®
Features
Operation
Halogen Lamp Warning
Advertisement
