Table of Contents
Advertisement
APSNUG.book Page 19 Tuesday, May 4, 1999 11:13 AM
Error Message
Parallel Port Conflict
Real-time Clock Error
CMOS Battery Bad
CMOS Checksum Error
NVRAM Checksum Error
Onboard XXX... Conflicts
PCI Device Error
System Resource Conflict
IRQ Setting Error
Expansion ROM Address
Allocation Fail
RAM Parity Error
I/O Parity Error
Press Ctrl_Alt_Esc key to enter
Setup or F1 key to continue
Press 1 key to enter Setup or
other key to continue
Corrective Action
Change the onboard parallel port
address in Setup or the parallel port
address of the add-on card.
Check the RTC circuit or replace the
battery.
Replace the onboard lithium battery.
Run Setup again and reconfigure the
system.
Run the EISA configuration utility
(ECU) to restore the original EISA
configuration data.
Try to reassign or disable onboard
device resources.
Check the PCI card. Replace it if bad.
Run Setup to reconfigure the system.
Run Setup to reconfigure the system.
Change the I/O expansion ROM
address.
Replace the memory modules or
disable parity check in Setup if the
model supports the feature.
Check all I/O related circuits (i.e.,
system I/O controller, memory
controller, interrupt controller, DMA
controller, etc.).
Press Ctrl-Alt-Del to enter Setup and
reconfigure the system.
Press 1 to enter Setup and check the
configuration. Pressing other keys
prevent entering Setup.
19
Advertisement
Table of Contents
