Pulling Up The Bobbin Thread - Brother NS-40 Operation Manual

SEWING BASICS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Pulling up the bobbin thread

When making gathers or before free-motion quilting,
first pull up the bobbin thread as described below.
a Insert the bobbin into the bobbin case.
a
• Refer to steps through
the bobbin" (page 18).
b Pass the bobbin thread through the slot.
Do not cut the thread with the cutter.
c While lightly holding the upper thread with
your left hand with the needle in the up-
position, press
twice to lower and raise the needle.
1
a Needle position button
The bobbin thread is looped around the
upper thread and can be pulled up.
d Carefully pull the upper thread upward to pull
out the end of the bobbin thread.
52
d
of "Installing
(needle position button)
e Pull out about 10-15 cm (4-5 inches) of the
bobbin thread under the presser foot toward
the rear of the machine.
Reattach the bobbin cover.
f
Insert the tab in the lower-left corner of the
bobbin cover (A), and then lightly press down
on the right side (B).
A A
B