Brother NS-40 Operation Manual page 26

Raise the presser foot lever, pass the end of
d
the thread through the presser foot, and then
pull out about 5 cm (2 inches) of thread
toward the rear of the machine.
a 5 cm (2 inches)
The upper threading is finished.
Now that the upper threading and the
lower threading are finished, you are
ready to begin sewing.
Note
● If the needle is not raised, the needle
threader cannot thread the needle. Be sure
to press (needle position button) to raise
the needle before using the needle threader.
■ For models without the thread guide disk
While lowering the needle threader lever,
a
hook the thread onto the guide.
a Needle threader
b Thread
c Guide
b
a
c
d
Catch the thread on the hook as shown below.
a
a Needle threader lever
Raise the needle threader lever, and then pull
the end of the thread which passed through
the eye of the needle.
CAUTION
● Be careful not to pull on the thread with force
or it may bend the needle.
Raise the presser foot lever, pass the end of
the thread through the presser foot, and then
pull out about 5 cm (2 inches) of thread
toward the rear of the machine.
a 5 cm (2 inches)
The upper threading is finished.
1
a
25