Download Print this page

AllTrade Trades Pro 835081 User Manual

2 gallon

Advertisement

Quick Links

FOR CUSTOMER SERVICE
POUR LE SERVICE APRÉS VENTE
OU DU CONSOMMATEUR
PARA EL SERVICIO PARA EL CONSUMIDOR
1-800-423-3598
ALLTRADE TOOLS LLC
1431 VIA PLATA, LONG BEACH, CA 90810-1462
www.alltradetools.com
MADE IN / FABRIQUÉ EN / HECHO EN CHINA
© COPYRIGHT 2003, ALLTRADE TOOLS LLC REV. 1
2

Air Compressor

Compresseur D'Air
Compresor de Aire
Gallon
Please retain these instructions for future reference.
If you encounter any problems or difficulties,
please contact our toll free Customer Service Department at:
1-310-522-9008 (California only)
Prière de conserver ces instructions pour pouvoir y référer à l'avenir.
En cas de problèmes ou de difficultés,
prière de contacter notre Service Après-Vente au numéro d'appel gratuit:
1-310-522-9008 (En Californie seulement)
Por favor, guarde estas instrucciones para que le sirvan de referencia en el futuro.
Si usted se encuentra con algún problema o dificultad, por favor, comuníquese con nuestro
Departamento de Servicios para el Consumidor, llamando de forme gratuita al:
1-310-522-9008 (solamente dentro del estado de California)
1-800-423-3598
1-310-522-9066 Fax
1-800-423-3598
1-310-522-9066 Fax
1-800-423-3598
1-310-522-9066 Fax
Model #835081
Modelo #835081

Advertisement

loading

Summary of Contents for AllTrade Trades Pro 835081

  • Page 1: Air Compressor

    OU DU CONSOMMATEUR MADE IN / FABRIQUÉ EN / HECHO EN CHINA PARA EL SERVICIO PARA EL CONSUMIDOR 1-800-423-3598 © COPYRIGHT 2003, ALLTRADE TOOLS LLC REV. 1 Air Compressor Compresseur D’Air Compresor de Aire Gallon Please retain these instructions for future reference.
  • Page 2 1. After opening the carton, please remove all parts and check against photograph on carton. If any parts are missing, please call Alltrade at 1-800-423-3598. 2. Close the drain valve on the bottom of the air tank by turning the valve clockwise until fully closed.
  • Page 3 Troubleshooting: 1. The compressor will not run. Probable cause: 1. No power, or the switch is in the “OFF” position. 2. Motor overheated 3. Tank Pressure at maximum Solutions: 1. Make sure the compressor is plugged in and the switch is in the “ON position.