System Overview Block Diagram; Automation - Hayward OnCommand® Operation Manual

The OnCommand is a multifunction pool controller used to fully manage your pool/spa system. The OnCommand
can control pumps, valves, lighting, heaters, and chlorination. Although the OnCommand is easy to use, it is
important to completely read through this operating manual before attempting to operate the control.
Optional Wireless
Spaside Remote
G LD LIN E
C O NT RO LS INC .
POOL VAL VES SPA
ON OFF
F ILT E R
ON H EAT ER OFF
ON L IG H TS OFF
ON OFF
A U X1
ON OFF
A U X2
Heater
Pool/Spa Suction
24V Valve
& Return Valves
Actuators
Valve 3
Water
Temperature
Air
Sensors
Solar
NOTE: This manual assumes that the OnCommand has been wired and configured according to the Installation
Manual. Aspects of the OnCommand that pertain to system setup are not covered in this manual.

Automation

The OnCommand can control up to 4 high voltage (120/240V) pieces of equipment, up to 3 automatic valve
actuators, and a conventional and solar heater. Both manual and automatic (programmed) operation are available.
All of the control functions are programmed at the unit's display/keypad. Although the OnCommand has no built-
in chlorinator feature, it can control an external Goldline Aqua Rite or Hayward Swimpure chlorinator.
System Overview
Optional
Wireless Base
Receiver
Optional
External Chlorinator
(requires Aqua Rite)
120 VAC
Power
Main Display
Keypad on Panel
1
Filter Pump
Lights
120/240V
Relays
Aux 1
Aux 2