Set Up Second Drive - Cisco Linksys NAS200 User Manual

Chapter 2
2. For the public folder, keep the default drive letter, or
select a different letter from the drop-down menu.
Click Next.
Map Network Drive
3. To install the Linksys Network Drive Mapping Utility on
your computer, click Yes.
Install Drive Mapping Utility
4. T he Setup Wizard automatically installs the utility.
Click OK.
Drive Mapping Utility Installed
Network Storage System with 2 Bays
Configuration Using the Setup Wizard
5. The network drive(s) are mapped to your computer.
Click Exit to exit the Setup Wizard, or click Next to
return to the Welcome screen.
Network Drive Mapped
The computer has been configured.

Set up Second Drive

NOTE: Make sure your second hard drive
is a 3.5-inch, Serial-ATA (SATA) hard drive.
If you plan to stripe (RAID 0) or mirror
(RAID 1) your drives, then match the drive sizes
for maximum drive use.
WARNING:
Low-profile or half-height hard
drives can be used at your own risk; however,
Linksys does not support the use of these drives
as they are not securely held in place inside the
Network Storage System.
Follow the instructions to add a second hard drive to
your previously configured Network Storage System. If
you physically install a second drive without running the
Setup Wizard, then the second drive will not be formatted.
It will have to be manually formatted using the web-based
utility (refer to "Chapter 3: Advanced Configuration").
4