Yamaha MX61 Reference Manual page 66

Performance
Parameter
CtrlReset
Determines the status of the controllers (Modulation Wheel, Foot Controller, Knobs, etc.) when switching
(Controller Reset)
between Voices. When this is set to "hold," the controllers are kept at the current setting. When this is set to
"reset," the controllers are reset to the default states (below).
Settings: hold, reset
If you select "reset," the controllers will be reset to the following states/positions. As for controllers that are
not actually available on the instrument itself (for example, After Touch, Ribbon Controller, and Breath
Controller), these functions can be enabled by transmitting the corresponding MIDI control number from an
external MIDI controller.
Pitch Bend
Modulation Wheel
After Touch
Foot Controller
Footswitch
MIDI Sync
Determines whether Song/Pattern/Arpeggio playback will be synchronized to the instrument's internal clock
or an external MIDI clock.
Settings: internal, external, auto
internal..... Synchronization to internal clock. You can use this setting when this tone generator is to be used
external.... Synchronization to a MIDI clock received from an external MIDI instrument via MIDI. Use this
auto.......... When MIDI clock is transmitted continuously from an external MIDI device or computer, the
NOTE
When setting the MX49/MX61 so that Song/Pattern/Arpeggio playback is synchronized to an external MIDI
clock, make sure to set the devices so that the MIDI clock from the DAW software/ external MIDI device is
properly transmitted to the MX49/MX61.
ClockOut
Determines whether MIDI clock (F8) messages will be transmitted via the MIDI OUT/USB terminal.
(MIDI Clock Out)
Settings: off, on
SeqCtrl
Determines whether or not Sequencer Control signals—start, continue and stop—will be received and/or
(Sequencer Control)
transmitted via MIDI.
Settings: off, in, out, in/out
off............. Not transmitted/recognized.
in.............. Recognized, but not transmitted.
out............ Transmitted, but not recognized.
in/out........ Transmitted/recognized.
BasicCh
Determines the MIDI transmit/receive channel for an entire Performance.
(Basic Channel)
Settings: 1 – 16, off
NOTE
The MIDI transmit/receive channel for Part 1–16 is fixed to 1 – 16 regardless of the "BasicCh" setting.
DeviceNo.
Determines the MIDI Device Number. This number must match the Device Number of the external MIDI
(Device number)
device when transmitting/receiving bulk data, parameter changes or other System Exclusive messages.
Settings: 1 – 16, all, off
RcvBulk
Determines whether or not Bulk Dump data can be received.
(Receive Bulk switch)
Settings: protect (not received), on (received)
BulkInterval
Determines the interval time of the Bulk Dump transmission when the Bulk Dump function is used or a Bulk
(Bulk Dump Interval)
Dump Request is received.
Settings: 0 – 900 ms
MX49/MX61 Reference Manual
Song/Pattern
Center Ribbon Controller
Minimum Breath Controller
Minimum Assignable Function
Maximum Expression
off
alone or as the master clock source for other equipment.
setting when an external sequencer is to be used as the master.
internal clock of the MX49/MX61 is automatically disabled and the MX49/MX61 is synchronized
with the external clock. When MIDI clock is not transmitted from the external MIDI device or
computer, the internal clock of the MX49/MX61 continues to run in sync with the latest received
tempo of the external MIDI device or computer (DAW software). This setting is useful when you
wish to alternate between external clock and internal clock.
File Utility
Description
Center
Maximum
off
Maximum
Remote
Utility
General
MIDI
Controllers
Remote
Utility Job
QuickSeup
Factory Set
Version
66