Selecting A Startup Device; Selecting A Temporary Startup Device; Selecting Or Changing The Startup Device Sequence - Lenovo ThinkCentre A57e User Manual

To set the Floppy A, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on
2. From the Setup Utility program menu, select Devices → Floppy Drive Setup →
3. Select the desired settings and press Enter.
4. Return to the Setup Utility program menu and select Exit → Save Changes and

Selecting a startup device

If your computer does not start up from a device such as the CD/DVD-ROM,
diskette, or hard disk drive as expected, use one of the following procedures to
select a startup device.

Selecting a temporary startup device

Use this procedure to startup from any start device.
Note: Not all discs, hard disk drives, and diskettes are bootable.
1. Turn off your computer.
2. Press and hold the F12 key, then turn on the computer. When the Startup
3. Select the desired startup device from the Startup Device Menu and press Enter
Note: Selecting a startup device from the Startup Device menu does not

Selecting or changing the startup device sequence

To view or permanently change the configured startup device sequence, do the
following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on
2. Select Startup → Startup Sequence.
3. See the information displayed on the right side of the screen.
4. Select the devices for the Primary Startup Sequence, the Automatic Startup
5. From the Setup Utility menu, select Exit → Save Changes and Exit.
If you have changed these settings and want to return to the default settings, select
Load Default Settings on the Exit menu.
Note: If you do not want to save the settings, select Discard Changes and Exit.
page 19.
Floppy A.
Exit.
Note: If you do not want to save the settings, select Discard Changes and Exit.
Device Menu appears, release the F12 key.
Note: If you are using a USB keyboard and the Startup Device Menu does not
display using this method, repeatedly press and release the F12 key
rather than leaving it pressed when turning on the computer.
to begin.
permanently change the startup sequence.
page 19.
Sequence, and the Error Startup Sequence.
Chapter 5. Using the Setup Utility
21