Table of Contents
Advertisement
v Use 512 MB, 1 GB, or 2 GB memory modules in any combination up to a
maximum of 4 GB.
Note: Only DDR2 SDRAM DIMMs can be used.
To install or replace a memory module:
1. Open the computer cover. See "Opening the computer cover" on page 12.
2. Pivot the drive bay assembly upward to access the memory slots. See
"Accessing the system board components and drives" on page 14.
3. Remove any parts that might prevent your access to the memory slots.
4. Locate the memory slots.
5. Open the retaining clips.
Figure 7. Opening the retaining clips
If you are replacing an old memory module, open the retaining clips and
remove the memory module being replaced as shown.
Figure 8. Removing the old memory module
Chapter 2. Installing options and replacing hardware
15
Advertisement
Table of Contents
