Page 1
ATL1930W-HD Customer Help Line: 01422 263313 Opening Hours: Mon-Fri 8am-8pm, Sat 9am-4pm, Sun 11am-4pm Or visit our website at www.ekey.co.uk...
Page 6
Power HDMI SCART S-Video Video L(AV) R(AV) PC-IN HP RF...
Page 9
When the remote control batteries are exhausted do not break open or throw on a fire.Contact your local waste authority for disposal instructions...
Page 10
6 Press the VOL+ button to start Autosearch. The TV will start searching from the lowest frequency. When it finds a station, it will automatically store this in the first location and move to the next. When Autosearch is complete, the TV will display the first station found.
Use the VOL+ and VOL- buttons to adjust the hue of the picture.(only used in NTSC mode ) HDMI mode AUTO CONFIG: Press the VOL+ button to have the following settings configured automatically. H/V-POSITION: Use the VOL+/- buttons to AUTO CONFIG adjust the position of the picture on the screen.
Page 15
.In the UK “I” is used. “BG” for Western Europe, “DK” Eastern Europe. To select a channel to be skipped use the VOL+ and VOL- buttons. Use theVOL+and VOL- buttons to turn the AFC (auto frequency control) ON or OFF Use the VOL+ or VOL- buttons to adjust the fine tuning if you experience problems with a weak signal or interference from another station.
Page 16
Press the VOL+ button to start Autosearch. The TV will start searching from the lowest frequency. When it finds a station, it will automatically store this in the first location and move to the next. When Autosearch is complete, the TV will display the first station found. In most cases, the stored stations will not be in the correct order, therefore you must use the "SWAP"...
Page 17
GENERAL MENU LANGUAGE ENGLISH BLUE SCREEN NOISE REDUCE INPUT SOURCE TXT LANGUAGE Pan European TXT EAST/WEST WEST ZOOM 16:9 RESET You can select language from: English, French, Spanish, German, Russian and Italian. Use the VOL+/- buttons to select: OFF, LOW, MID, HIGH. HDMI TXT Language Use the...
Trouble Shooting Guide Should you experience problems, please consult the guide below before returning to point of Symptom Possible fault Remedy Dead. No led lit Power not connected Check the power supply module is connected and turned on Dead Led lit Red Set stuck in standby Press Power button on the Tv or Remote Control...
Specifications TV System PAL BG/DK/I SECAM BG/DK Screen size 19 "(diagonal) Resolution 1440 x 900 pixels (RGB) VGA suggest Mode 1024x768 60Hz Contrast ratio 500:1 Brightness 300cd/m*2 Audio output power 2x3 W Mains power 12V 5A Power consumption Remote control Type infrared Control distance...
Need help?
Do you have a question about the ATL1930W-HD and is the answer not in the manual?
Questions and answers