Control Panel (Ice Dispenser); Before Use; Using The Freezer; To Start The Freezer And Set The Correct Temperature - Electrolux U29251 EUFG2900 Instruction Booklet

Control Panel
(ice dispenser)
H I
H. Yellow indicator lamp
Lights up when the locking function has been
activated.
I. Button for locking function.
Used for temporary disconnection of the locking
function and alarm re-setting.
J. Button for night setting/lighting.
Used for activation/deactivation of the night setting
function and to switch the lighting and the alarm

Before use

Position and clean the cabinet as explained in the
section "Installation".
Before inserting the power plug into the
outlet and switching on the cabinet for
the first time, leave it standing upright
for about 4 hours. Otherwise the
compressor may sustain damage. This
time will allow the oil sufficient time to
return to the compressor.

Using the freezer

To start the freezer and set the
correct temperature
Switching on:
Switch on the freezer by pressing the power switch.
The alarm sounds if the temperature inside the
freezer reaches room temperature. Turn off the alarm
by pressing the switch-off button.
Setting the temperature
Press the buttons until the desired temperature blinks
on the temperature display. (The temperature can be
set between -15°C and -24°C.)
"+" increases the temperature.
"-" decreases the temperature.
M
J
L
setting on and off.
K. Photo-electric sensor.
Senses prevailing lighting conditions (must not be
covered).
L. Ice feeder
Activated when the paddle in the feeder is fully
depressed.
M. Lighting
4
K
--18
20
--18
Electrolux 818 38 03-01/7
GB
GB
*
ACTION FREEZE
*
ACTION FREEZE
*
ACTION FREEZE