Mhz Deviation Adjustment (Vc-215 Board); Bpf Adjustment (Vc-215 Board) - Sony CCD TRV16 - Hi8 Handycam Camcorder Service Manual

3-6. AUDIO SYSTEM ADJUSTMENT
[Connecting the measuring instruments for the audio]
Connect the audio system measuring instruments besides the video
system measuring instruments as shown Fig. 5-3-25.
• Connection of Audio generator and attenuator.
Audio
generator
Attenuator
Parts cord 600 Ω :
270 (1-249-410-11) + 330 (1-249-411-11)
• Connection of Audio level meter or distortion meter
AUDIO
terminal
Parts cord 47k Ω : 1-249-437-11
Fig. 5-3-21.
600 Ω
AUDIO
terminal
Audio level meter
or distortion meter
47k Ω

1. 1.5 MHz Deviation Adjustment (VC-215 board)

Adjust to the optimum audio FM signal distortion.
If the adjustment is not correct, its playback level will differ from
that of other units.
Mode Playback
Signal Alignment tape:
Measurement Point Audio output terminal
Measuring Instrument Audio level meter
Adjustment Page F
Adjustment Address 46
Specified Value –7.5±0.5dBs
Adjusting method :
1) Select page: 0, address: 01, and set data: 01.
2) Select page: F, address: 46, change the data and set the 400Hz
signal level to the specified value.
3) Press the PAUSE button of the adjusting remote commander.
4) Select page: 0, address: 01, and set data: 00.

2. BPF Adjustment (VC-215 board)

Adjust to the optimum audio BPF characteristics of the IC.
If the adjustment is not correct, the distortion rate and S/N ratio will
worsen.
Mode Playback
Signal Alignment tape:
Measurement Point Audio output terminal
Measuring Instrument distortion meter
Adjustment Page F
Adjustment Address 47
Specified Value The distortion rate should be and
minimum.
Adjusting method :
1) Select page: 0, address: 01, and set data: 01.
2) Select page: F, address: 47, change the data and minimize the
distortion rate.
3) Press the PAUSE button of the adjusting remote commander.
4) Select page: 0, address: 01, and set data: 00.
For checking the operation
(WR5-5CSP)
For BPF adjustment
(WR5-11CS)