Back-Panel Features And Indicators - Dell PowerVault DL2300 Owner's Manual

Back-Panel Features And Indicators

Figure 3. Back-Panel Features and Indicators
Item Indicator, Button, or
Connector
1 System identification button
2 System identification
connector
3 iDRAC7 Enterprise port
4 PCIe expansion card slots
low–profile (3)
5 Serial connector
6 Video connector
7 USB connectors (2)
8 Ethernet connectors (4)
Icon Description
The identification buttons on the front and back panels
can be used to locate a particular system within a rack.
When one of these buttons is pressed, the system status
indicator on the back flashes until one of the buttons is
pressed again.
Press to toggle the system ID on and off.
If the system stops responding during POST, press and
hold the system ID button for more than five seconds to
enter BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup) press
and hold the button for more than 15 seconds.
Connects the optional system status indicator assembly
through the optional cable management arm.
Dedicated management port.
NOTE: The port is available for use only if the iDRAC7
Enterprise license is installed on your system.
Allows you to connect up to three PCI Express expansion
cards.
Allows you to connect a serial device to the system.
Allows you to connect a VGA display to the system.
Allows you to connect USB devices to the system. The
ports are USB 2.0-compliant.
Four integrated 10/100/1000 Mbps NIC connectors
or
Four integrated connectors that include:
• Two 10/100/1000 Mbps NIC connectors
• Two 100 Mbps/1 Gbps/10 Gbps SFP+/10 GbE T
connectors
13