Advertisement
7
Remove pivot jamb with threshold. Drill six holes using a
3/16" drill bit. (Use a masonry bit for ceramic tile.)
Insert one screw anchor in each hole.
NOTE: When drilling into fiberglass or plastic walls, use a
1/8" drill bit and do not use screw anchors.
9
Subtract door panel width DW from length W in step 1. If
difference is from 1-3/4" to 3-1/8" use the minimum hole.
If difference is from 3-1/8" to 4-1/2" use maximum hole.
Insert one nylon pivot bushing in each of selected holes top
and bottom.
1-3/4" < W – DW < 3-1/8"
ADJUSTMENT HOLE
DOOR
3-1/8" < W – DW < 4-1/2"
WIDTH
ADJUSTMENT HOLE
DW
W
W
— DW
11
On side opposite pivot jamb, drill a 1/8" hole in threshold
located 5/8" from wall and 7/8" from flat edge of threshold.
Fasten positioning spacer to threshold using one #8 x 1"
pan head screw.
For doors with narrow strikes (e.g. Model #804NS) position-
ing spacer is not necessary. Instead mark a line 7/8" in from
flat edge and parallel to it. Center adjustment rail over this
line when installing in step #12.
#8 x 1" Pan Head Screw (Actual Size)
SCREW ANCHOR
IF
USE MINIMUM
NYLON PIVOT
BUSHING
IF
MIN
USE MAXIMUM
HOLE
inches
inches
inches
POSITIONING
SPACER
5/8"
7/8"
8
Apply 1/4" bead of silicone caulk where bottom of pivot
jamb and threshold meet (see inset detail).
Mount assembled pivot jamb to wall using six #8 x 1-1/2"
flat head screws.
#8 x 1-1/2" Phillips Flat Head Screw (Actual Size)
10
Install door by mating bottom pivot bolt with nylon pivot bushing.
Align door with top pivot arm and insert pivot bolt through arm
into 1/4" nut, and then into corresponding nylon pivot bushing.
Adjust door by sliding it in pivot slot top and bottom to allow
1-3/8" to 1-7/8" of space between wall and magnet side of door
when in closed position.
Tighten nut against pivot arm for proper tension using 1/4"
MAX
wrench.
HOLE
1/4" WRENCH PROVIDED
12
Temporarily secure threshold with masking tape at strike
side. Ensure an even distance between edge of threshold
and front of the base.
Locate adjustment rail over positioning spacer and against
wall (you may reverse rail to mark holes). Use a level to
plumb adjustment rail.
Mark hole location of the large holes only. Remove rail. Drill
six 3/16" diameter holes then insert wall anchors.
ADJUSTMENT
RAIL
Plastic Screw Anchor (Actual Size)
3
SILICONE
CAULK
TOP VIEW
7 1 0 0 0 7 - 1 0 0
Advertisement
