Advertisement
Quick Links
Owner's Manual
PIVOT SHOWER DOORS
Thank you for selecting our product...the benchmark of fine quality for over 100 years. To ensure that your installation
proceeds smoothly--please read these instructions carefully before you begin.
Record Model Number _______________
BEFORE YOU BEGIN...
Local building codes vary by location. Observe all local plumbing and building codes.
Unpack your new shower doors and inspect them carefully for damage. Verify that the doors are the correct size for your installation.
TOOLS & MATERIALS REQUIRED...
• Tape Measure • Electric Drill • Level • Phillips and Flat Screwdrivers • Drill Bits 1/8" & 3/16" • Hacksaw • Silicone Caulk
IMPORTANT: Record the Model No. (see carton) of your shower or tub enclosure for future reference.
READ THE INSTRUCTIONS CAREFULLY: Familiarize yourself with all the parts as shown in the exploded view. The exploded view
will also provide a helpful reference when relating the location of the various parts and how they are mounted.
22
7
17
19
18
8
21
20
9
24
16
11
6
12
13
10
22
1
1
7 1 0 0 0 7 - 1 0 0
Model No. ____________
23
5
3
15
4
14
Advertisement
Summary of Contents for American Standard Showerite Owner’s
- Page 1 Owner’s Manual PIVOT SHOWER DOORS Thank you for selecting our product...the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin. Record Model Number _______________ 7 1 0 0 0 7 - 1 0 0 BEFORE YOU BEGIN...
-
Page 2: Installation Procedures
INSTALLATION PROCEDURES: Determine side at which the door will pivot (left or right). Flat edge of threshold should face inside of shower. The pivot side should be opposite the showerhead. Identify end of threshold which will be pivot side. Measure width of the opening at the centerline of bottom. Mark the OPPOSITE end for drilling. - Page 3 Remove pivot jamb with threshold. Drill six holes using a Apply 1/4" bead of silicone caulk where bottom of pivot 3/16" drill bit. (Use a masonry bit for ceramic tile.) jamb and threshold meet (see inset detail). Insert one screw anchor in each hole. Mount assembled pivot jamb to wall using six #8 x 1-1/2"...
- Page 4 Remove debris and clean threshold & base. Place magnetic jamb over adjustment rail with magnetic strip facing to outside of shower. Caulk end of threshold at wall per detail. Close door and adjust magnetic jamb to allow 1/8" to 1/4" clearance between magnetic jamb and door panel.
-
Page 5: How To Order Replacement Parts
HOW TO CARE FOR YOUR ENCLOSURE Do not use scouring powder, pads or sharp instruments on metal or glass panels. Occasionaly wipe with mild detergent diluted in water to keep the panels and metal parts looking new. Use squeegees following each shower to eliminate water spots on the inside of the glass panels. HOW TO ORDER REPLACEMENT PARTS Provide the following information to your Dealer. - Page 6 WARRANTY FOR SHOWER DOORS AS America, Inc. (“American Standard”) warrants to the original consumer purchaser that it will, at its sole option, repair or replace this product or any part of this product, if it confirms that the product is defective in materials or workmanship under normal use and maintenance for the lifetime of this product.