Gigabyte GA-M55S-S3 User Manual page 77

(6) Configuring a bootable RAID array with Microsoft Windows 2000
Problem: Users cannot install Windows 2000 with Service Pack 2 (or previous versions) to a bootable
RAID volume.
There are two solutions to resolve this issue.
Solutions 1:
Use the NVRAID tool (nForce Driver Version 5.xx) to convert the boot volume to a RAID array. Here
are the detailed step-by-step instructions:
Step 1:
Install Windows 2000 onto a selected hard drive. Download and install Windows 2000 Service Pack 4
from Microsoft's website.
Step 2:
After system restarts, press Del to enter system BIOS Setup during POST (Power-On Self Test). Under
the Integrated Peripherals menu assure the SATA port connecting the SATA hard disk (the one
containing the Windows 2000) is Enabled (Figure 19/20). Save settings and exit the BIOS setup.
CMOS Setup Utility-Copyright (C) 1984-2006 Award Software
Serial-ATA RAID Config
On-Chip IDE Channel0
On-Chip MAC Lan
NV Serial-ATA Controller
IDE Prefetch Moed
Onboard Audio Function
SMART LAN
Onboard 1394
Onboard LAN Boot ROM
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
On-Chip USB
USB Keyboard Support
USB Mouse Support
Legacy USB storage detect
: Move Enter: Select
F5: Previous Values
CMOS Setup Utility-Copyright (C) 1984-2006 Award Software
NV SATA RAID function
NV SATA 1 Primary RAID
NV SATA 1 Secondary RAID
NV SATA 2 Primary RAID
NV SATA 2 Secondary RAID
: Move Enter: Select
F5: Previous Values
Integrated Peripherals
[Press Enter]
[Enabled]
[Auto]
[All Enabled]
[Enabled]
[Auto]
[Press Enter]
[Enabled]
[Disabled]
[3F8/IRQ4]
[378/IRQ7]
[SPP]
3
[V1.1+V2.0]
[Disabled]
[Disabled]
[Enabled]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
Figure 19
Serial-ATA RAID Config
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
Figure 20
- 77 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults
Appendix