Cleaning The Cover Of Your Computer - Lenovo ThinkPad Edge E120 User Manual

• Before you install any of the following devices, touch a metal table or a grounded metal object. This action
reduces any static electricity from your body. The static electricity could damage the device.
– Memory module
– Mini-PCI Card
– Memory Card, such as SD Card, SDHC Card, SDXC Card, and MultiMediaCard.
Note: Not all listed devices are included in your computer.
This action reduces any static electricity from your body. The static electricity could damage the device.
• When transferring data to or from a flash media card, such as an SD card, do not put your computer
in sleep (standby) or hibernation mode before the data transfer is complete. To do so might cause
damage to your data.
Take care in setting passwords
• Remember your passwords. If you forget a supervisor or hard disk password, Lenovo will not reset it, and
you might have to replace your system board, or hard disk drive or solid state drive.
Register your computer
• Register your ThinkPad products with Lenovo (refer to the Web page: http://www.lenovo.com/register).
This can help authorities return your computer to you if it is lost or stolen. Registering your computer also
enables Lenovo to notify you about possible technical information and upgrades.
Be sure not to modify your computer
• Only an authorized ThinkPad repair technician should disassemble and repair your computer.
• Do not modify or tape the latches to keep the display open or closed.

Cleaning the cover of your computer

Occasionally clean your computer as follows:
1. Prepare a mixture of a gentle kitchen-use detergent (one that does not contain abrasive powder or
strong chemicals such as acid or alkaline). Use 5 parts water to 1 part detergent.
2. Absorb the diluted detergent into a sponge.
3. Squeeze excess liquid from the sponge.
4. Wipe the cover with the sponge, using a circular motion and taking care not to let any excess liquid drip.
5. Wipe the surface to remove the detergent.
6. Rinse the sponge with clean running water.
7. Wipe the cover with the clean sponge.
8. Wipe the surface again with a dry, soft lint-free cloth.
9. Wait for the surface to dry completely and remove any fibers from the cloth.
Cleaning your computer keyboard
1. Apply some isopropyl rubbing alcohol to a soft, dust-free cloth.
2. Wipe each keytop surface with the cloth. Wipe the keys one by one; if you wipe several keys at a time,
the cloth may hook onto an adjacent key and possibly damage it. Make sure that no liquid drips onto
or between the keys.
3. Allow to dry.
4. To remove any crumbs or dust from beneath the keys, you can use a camera blower with a brush
or cool air from a hair dryer.
116
User Guide