AEG ARCTIS 818 35 94-01/2 Operating Instructions Manual page 31

Malfunction
The appliance is over-
cooling.
The freezer compartment
temperature is insufficient.
Interior illumination does
not function.
Accumulation of frost at
the door seal.
Unusual noises.
The compressor does not
start immediately after
pressing the TURBO/
FROSTMATIC button, or
after changing the
temperature setting.
818 35 94-01/2
Possible cause
The temperature has been
set too low.
Temperature is not properly
adjusted.
Door was open for a long
time.
Within the last 24 hours a
large quantity of warm
foods were loaded.
Appliance is next to a
source of warmth.
Light bulb is defective.
Door is not properly sealed
(perhaps after reversing
the door).
Appliance is not level.
Appliance is in contact
with wall or other objects.
A part at the back of the
appliance, e.g. a tube, is in
contact with another
appliance part or the wall.
This is normal, no error has
occurred.
What to do if ...
Remedy
Temporarily select a higher
temperature setting.
Please refer to the section
"Temperature Adjustment".
Only leave the door open
as long as necessary.
Press TURBO/FROSTMATIC
button.
Please refer to the section
"Installation Location".
Please refer in this chapter
under "Replace light bulb" .
Carefully warm the door
seal with a hand-held hair
dryer at those points which
are not airtight (no warmer
than approx. 50°C). At the
same time, shape the
warmed door seal by hand,
so that it is again properly
seated.
Readjust the front levelling
feet.
Push appliance away a
short distance.
Bend this part away
carefully if necessary.
The compressor starts after
a period of time.
31