General Setup - Alpine TME-M740BT Owner's Manual

CINEMA: The monitor displays a normal picture by stretching out
the picture vertically. This mode is good for displaying a
cinema type picture at the 16 : 9 ratio.
CINEMA
NORMAL: The monitor displays a normal picture at the centre of the
screen with a vertical black band at each side.
NORMAL
Adjusting the Touch Panel (SCREEN ALIGNMENT)
(RESET) / (SETUP)
Adjustment becomes necessary when the display position on
the LCD and the touch position on the touch panel do not match.
1
Touch [ ] of SCREEN ALIGNMENT.
The adjustment screen appears.
2
Accurately touch the [
left corner of the screen.
The screen changes to the adjustment screen.
3
Accurately touch the [ ] mark provided in the upper
right corner of the screen.
This completes adjustment, and returns to the DISPLAY
setup mode screen.
• If the setting is cancelled half way, press SOURCE.
VISUAL EQ™ Setting
BRIGHT
MIN(-15) to MAX(+15) (Initial Setting: 0)
COLOR
MIN(-15) to MAX(+15) (Initial Setting: 0)
TINT
G MAX(G15) to R MAX(R15) (Initial Setting: 0)
CONTRAST
MIN(-15) to MAX(+15) (Initial Setting: 0)
SHARP
MIN(-15) to MAX(+15) (Initial Setting: 0)
] mark provided in the lower
VISUAL EQ MODE
OFF(Initial Setting) / NIGHT M / SOFT / SHARP / CONTRAST / P-1
/ P-2
OFF : Initial Setting
NIGHT M.: Suitable for movies in which dark scenes frequently
appear.
SOFT: Suitable for CGs and animated films.
SHARP: Suitable for old movies where images are not clearly
shown.
CONTRAST: Suitable for recent movies.
P-1: Recalls the VISUAL EQ mode being stored on preset
No.P-1 from " USER MEMORY" (page 12).
P-2: Recalls the VISUAL EQ mode being saved on preset
No.P-2 from " USER MEMORY" (page 12).
USER MEMORY
P-1 (Initial Setting) / P-2
You can store the settings made for "
TINT, CONTRAST and
After adjusting BRIGH,
CONTRAST and SHARP, select the preset number (P-
1) or (P-2) and store it by touching [WRITE].
• You can recall the VISUAL EQ mode stored here from P-1 or P-2 of
" VISUAL EQ Mode" (page 12).

GENERAL Setup

Sound (Beep) Guide Function (BEEP)
ON (Initial Setting) / OFF
ON: Activate the Sound Guide mode.
OFF: Deactivate the Sound Guide mode. The sound guide beep will
not be produced when a button on the unit is pressed.
Adjusting the Brightness of the LED (LED BRIGHTNESS)
HIGH / NORMAL (Initial Setting) / LOW / OFF
You can set LED brightness (POWER indicator, etc.).
HIGH: Makes LED brighter.
NORMAL: Normal LED brightness.
LOW: Makes LED darker.
OFF: Turns LED off.
Change Sound Output (VOLUME CONTROL)
MONITOR (Initial Setting) / SYSTEM
If the unit is connected to the Vehiclehub Pro (VPA-B222), set to
ON.
MONITOR: Outputs sound through the built-in speakers.
SYSTEM: Volume is adjustable from this unit if compatible devices
are connected to the VPA-B222.
BRIGH, COLOR,
SHARP."
COLOR, TINT,
11
-EN