Attach the TV to
Warning: Screens can be damaged
from direct pressure when handled
incorrectly. We recommend lifting the
TV by the edges, as shown.
Attach the TV to the Stand
REQUIRED TOOLS: a Phillips head screwdriver and a soft, flat surface larger than the TV
(such as the box).
x8 (M4 X L12)
Power on and
batteries into the
start the initial
Lay the TV on a soft surface, screen side down.
Use the packing material to protect the screen.
Put a base, legs and screws off to assemble the
stand out of the box.
Fit the stand and mount together, making sure
the notch on the mount aligns with the stand.
Insert 4 screws and secure the stand to the TV.
Welcome to your new Smart TV!
The following instructions cover assembling, connecting, and setting up your new TV. Make
sure you have the accessories listed below.
Included in this box
Smart Touch Control
Batteries (AAA x 2)
User Manual, regulatory guide, 3D Active Glasses,
x4 (M4 X L12)
Warning: Handling the TV incorrectly
can result in injury. After setting the
stand into the TV, we recommend not
lifting the TV using the stand. Lift it
by grabbing the front and bottom, as
Stand Parts and Cables
Remove the protection film from the bottom of the
TV and stand, as shown by the illustration.
Holding the stand parallel to the screen, slide the
stand into the notches on the back of the TV.
Fit the guide protrusion on each edge of the stand
in the matching hole on the sole of the TV.
Insert 2 screws and secure the stand to the TV.