Canon PowerShot SD100 Software Starter Manual page 123

117
Problems
Try the suggested solutions to the common problems listed below.
USB Driver installation not proceeding well (Windows)
Uninstall the driver (p. 111) before reinstalling it with the procedures in
Installing the Software and USB Driver (p. 10).
Add New Hardware Wizard or New Hardware Found (Windows
2000) Wizard displays when the camera is connected to the
computer with a USB cable.
Click [Cancel] to close the window. Temporarily disconnect the camera
from the computer. Next, read Start by Checking This on the previous page
and resolve the problem.
Connection confirmation message displays. (PowerShot G3,
3
PowerShot S45 and PowerShot S230 DIGITAL ELPH/DIGITAL IXUS v
only)
Cause:
The camera's [Auto Power Down] function is set to [On]. This
message displays if you do not access a function for a set period of
time (5 minutes) while the camera is connected to the computer via
the USB cable.
Solution 1:
Select one of the options in the dialog. The connection to the camera will
close after 1 more minute if you do not act. See the Camera User Guide for
instructions how to reactivate the camera if this occurs.
Solution 2:
Set the camera's [Auto Power Down] function to [Off]. See the Camera
User Guide.