Using The Mounting Bracket - Nextar X3-03 - Automotive GPS Receiver Hardware Manual

Using The Mounting Bracket

A suction cup mount is provided for attaching the GPS unit to the windshield or the
dashboard.
Assemble the bracket and cradle as shown below and then attach the GPS to the cradle.
1. Following the arrow,silde the mount cradle onto the mount bracket.
2. See Fig. 2. Fix the unit on the mount cradle.
3. See Fig. 3. Lift the suction cup lever and then press the suction cup to the
windshield. Following arrow(1),press down the suction cup lever. Then rotate the
knob to adjust the unit to proper position.
To mount to dashboard, use the included adhesive disk. Choose a clean, dry spot
on your dashboard, peel off protection liner from the back of the disk, and then
attach the disk to your dashboard.Note: Keep the suction cup and the interior of the
windshield clean to ensure good adhesion.
If you prefer to mount the unit to the dashboard, you may use the adhesive disk
1. Choose a clean, flat spot on your dashboard.
2. Peel off protection liner from the back of the disk.
3. Attach the disk to your dashboard.
4. Using the suction cup, attach the bracket to the adhesive disk.
10