Asus P5GD1 User Manual page 45

A
Hide thumbs Also See for P5GD1:
Table of Contents

Advertisement

3 . 3 .
3 .
3 .
I D E R A I D c o n n e c t o r s
I D E R A I D c o n n e c t o r s
I D E R A I D c o n n e c t o r s
3 .
I D E R A I D c o n n e c t o r s
I D E R A I D c o n n e c t o r s
( 4 0 - 1 p i n P R I _ R A I D [ b l u e ] , S E C _ R A I D [ b l a c k ] )
( 4 0 - 1 p i n P R I _ R A I D [ b l u e ] , S E C _ R A I D [ b l a c k ] )
( 4 0 - 1 p i n P R I _ R A I D [ b l u e ] , S E C _ R A I D [ b l a c k ] )
( 4 0 - 1 p i n P R I _ R A I D [ b l u e ] , S E C _ R A I D [ b l a c k ] )
( 4 0 - 1 p i n P R I _ R A I D [ b l u e ] , S E C _ R A I D [ b l a c k ] )
These connectors are for Ultra ATA 133/100/66 signal cables. These
connectors support up to four IDE hard disk drives that can be
configured as a disk array through the onboard IDE RAID controller.
Refer to Chapter 5 for details on how to set up RAID configurations.
These connectors are set to IDE mode by default. In IDE mode, you can
connect IDE devices to these connectors such as boot/data hard disk
drives or optical drives. If you intend to create an IDE RAID set using
these connectors, set the I T E 8 2 1 2 F C o n t r o l l e r
RAID Mode. See section "4.4.6 Onboard Devices Configuration" for
details.
P5GD1
P5GD1 RAID IDE connectors
Before creating a RAID set using Ultra ATA hard disks, make
sure that you have connected the Ultra ATA signal cable and
installed Ultra ATA 133/100/66 hard disk drives.
The system automatically assigns the boot sequence of ATAPI
devices connected to the IDE RAID connectors.
The ITE
disk drives.
Set both drives either as Master or Slave before configuring a RAID 1
set.
A S U S P 5 G D 1
A S U S P 5 G D 1
A S U S P 5 G D 1
A S U S P 5 G D 1
A S U S P 5 G D 1
I T E 8 2 1 2 F C o n t r o l l e r item in the BIOS to
I T E 8 2 1 2 F C o n t r o l l e r
I T E 8 2 1 2 F C o n t r o l l e r
I T E 8 2 1 2 F C o n t r o l l e r
NOTE: Orient the red markings
(usually zigzag) on the IDE
cable to PIN 1.
PRI_RAID
®
8212F controller supports a maximum of 2 Ultra ATA hard
SEC_RAID
PIN 1
2 - 2 5
2 - 2 5
2 - 2 5
2 - 2 5
2 - 2 5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents