Chipset - Asus P5E-VM SE User Manual

2.4.5

Chipset

The Chipset menu allows you to change the advanced chipset settings. Select an
item then press <Enter> to display the sub-menu.
Advanced
Advanced Chipset Settings
WARMING: Setting wrong values in below sections
may cause system to malfunction.
North Bridge Configuration
North Bridge Configuration
Advanced
North Bridge Chipset Configuration
Memory Remap Feature
Initiate Graphic Adapter
Internal Graphics Mode Select
PEG Port Control
PEG Port Force x1
Video Function Configuration
v02.58 (C)Copyright 1985-2007, American Megatrends, Inc.
Memory Remap Feature [Enabled]
Allows you to enabled or disable the remapping of the overlapped PCI
memory above the total physical memory. Enable this option only when you
install 64-bit operating system. Configuration options: [Disabled] [Enabled]
Initiate Graphic Adapter [PEG/PCI]
Allows you to decide which graphics controller to use as the primary boot device.
Configuration options: [IGD] [PCI/IGD] [PCI/PEG] [PEG/IGD] [PEG/PCI]
Internal Graphics Mode Select [Enabled, 8MB]
Allows you to decide whether to use the internal graphics device and select
the amount of memory used by the device.
Configuration options: [Disabled] [Enabled, 1MB] [Enabled, 8MB]
Set this item to [Disabled] if you intend to install a PCIE x16 graphics card to the
PCIE x16 slot.
2-24
BIOS SETUP UTILITY
BIOS SETUP UTILITY
[Enabled]
[PEG/PCI]
[Enabled, 8MB]
[Auto]
[Disabled]
Configure North Bridge
features.
ENABLE: Allow
remapping of
overlapped PCI memory
above the total
physical memory.
DISABLE: Do not allow
remapping of memory.
Select Screen
Select Item
+-
Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Chapter 2: BIOS setup