Table of Contents
Advertisement
5.4.2
JMicron
The JMicron
®
JBOD sets on the external Serial ATA hard disk drives.
Before creating a RAID set
Prepare the following items:
1.
Two SATA HDDs, preferably with the same model and capacity.
2.
A write-enabled floppy disk
3.
Microsoft
4.
Motherboard support CD with JMB363 driver
Complete the following steps before you create a RAID set:
1.
Install the external Serial ATA hard disk drives (HDDs) on your system.
Set the JMicron SATA Controller Mode item in the BIOS to [RAID]. See
2.
section "4.4.6 Onboard Devices Configuration" for details.
HD Audio Controller
Front Panel Support Type
Onboard PCIE GbE LAN
LAN Option ROM
JMicron SATA/PATA Controller
JMicron SATA Controller Mode
Serial Port1 Address
Parallel Port Address
Parallel Port Mode
ECP Mode DMA Channel
Parallel Port IRQ
3.
Enter the JMB363 RAID BIOS utility to set up your RAID configuration.
4.
Create a JMB363 RAID driver disk for Windows
"5.5 Creating a RAID/SATA driver disk" for details.
5.
Install the JMB363 driver after the Windows
Always install the JMB363 driver before creating RAID sets.
5-32
RAID Configuration
®
Serial ATA controller allows you to configure RAID 0, RAID 1 and
Windows
OS installation disk (Windows 2000/XP)
®
®
[Enabled]
[AC97]
[Enabled]
[Disabled]
[Enabled]
[RAID]
[3F8/IRQ4]
[378]
[ECP]
[DMA3]
[IRQ7]
®
OS had been installed.
®
OS installation. See section
Chapter 5: Software support
Advertisement
Table of Contents
