Brother DCP-J140W Quick Setup Manual page 26

Wireless Network
d
When this screen appears, choose Change
the Firewall port settings to enable network
connection and continue with the
installation. (Recommended) and click Next.
If you are using a firewall other than the
®
Windows Firewall or the Windows
off, this screen may appear.
See the instructions provided with your firewall
software for information on how to add the
following network ports.
For network scanning, add UDP port 54925.

 If you still have trouble with your network
connection, add UDP port 137 and 161.
e
Choose your machine from the list, and then
click Next.
Note
• If your wireless settings fail, the Wireless
Device Setup Wizard will appear during the
installation of MFL-Pro Suite. Confirm your
settings by following the on-screen
instructions. If you encounter this failure, go to
step 11-b on page 17 and setup the wireless
connection again.
• If you are using WEP and the LCD displayed
Connected but your machine is not found,
make sure you entered the WEP key correctly.
The WEP key is case sensitive.
26
f
The installation of the Brother drivers will
automatically continue. The installation
screens appear one after another.
Important
DO NOT cancel any of the screens during the
installation. It may take a few seconds for all
screens to appear.
Note
For Windows Vista
Windows
®
Firewall is
check box and click Install to complete the
installation correctly.
g
When the On-Line Registration screen is
displayed, make your selection and follow the
on-screen instructions.
h
If you do not want to set your machine as the
Default printer, uncheck Set as Default
Printer(This setting will be applied to the
current user.) and then click Next.
Note
We recommend you try the Trial Photo Print
selection to see the high quality output available
from your Brother machine.
The Trial Photo Print screen appears only once
after restarting.
Windows
® ®
and Windows
®
Security screen appears, click the
®
7, when the